Kenwood KDC-W9537U Instruction Manual

Also see for KDC-W9537U: Firmware update guide Service manual

English | 175 Select the Display ModeTurn the Control knob.Select from the following display mode:Mode "TYPE SELECT [B]" "TYPE SELECT [C]"B-1/C-1332930329B-2/C-255549505549B-3/C-3 690 696 Exit Display Mode Selection modePress the Control knob.⁄• 1, 2, 3, 4, 5, 6, 7, 8 Text display part9 Status display0 Icon display part! Graphic display part• To change the information by the Display Type, referto the page on the following table for the methods toalternate by the Display Type.Display Type A B-1 B-2 B-3 C-1 C-2 C-3 DText 1 18 — 18 — — 18 — —Text 3 — 18 — — 18 — — —Text 4 — — 18 — — 18 — —Text 5 — — 18 — — 18 — —Text 6 — — — 18 — — 18 —Text 7 — — — — — — — 18Status 9 17 — — — — — — —Icon 0 — — — — 19 19 19 —Graphic ! 17 — — — — — — —• With Display type D, text is displayed between the topand bottom rows when blank is set in the top or bottomrow.• Text display part 6If whole information cannot be displayed within fourrows, hold down on [FM] of the Control knob for atleast 1 second to display the remaining portion of theinformation.Display Type AStatus SettingDetermine whether the On and Off statuses ofvarious functions are to be displayed on the DisplayType A.1 Enter Status Setting modeUsing the Control knob, select "DISPLAY" >"STATUS".For the operation method, refer to Control mode> (page 11).2 Select the Status displayTurn the Control knob.3 Exit Status Setting modePress the Control knob.Display Type AGraphic Display SelectionChanging the graphic Display.1 Enter Graphic Display Selection modeUsing the Control knob, select "DISPLAY" >"GRAPHIC".For the operation method, refer to Control mode> (page 11).2 Select the graphic displayTurn the Control knob or push it towards leftor right.Select from the following displays:Graphic display DisplayMovie 1 – 2Spectrum analyzer 1 – 8Wallpaper 1 – 12Downloaded Wallpaper*Wallpaper scan "SCAN"* For Download Wall Paper, refer to (page 45).3 Exit Graphic Display Selection modePress the Control knob.⁄• During standby, Spectrum analyzer cannot be selected.