Kenwood KDC-X395 Instruction Manual

Also see for KDC-348U: Brochure & specs Instruction manual Service manual

Kenwood KDC-X395 Instruction Manual Manual pdf 26 page image

26 EnglishSatellite Radio Tuner Control1 Press SRC to select “SIRIUS” or “XM”.2 Press BAND repeatedly to select a band(SR1/ SR2/ SR3/ SR4 ; XM1/ XM2/ XM3/XM4).3 Press 4 / ¢ to search for a channel.■ You need to register to the service providerto receive the service by Satellite Radio.Consult the service provider if “CALL … TOSUBSCRIBE” appears.■ The radio may take a little time to startreceiving after you select the Satellite Radiosource.■ If the signal reception fails, “ACQUIRINGSIGNAL”/ “NO SIGNAL” appears.Category and Channel Search1 Press to enter Category and ChannelSearch mode.2 Turn the volume knob to select acategory, then press to confirm.3 Turn the volume knob to select achannel, then press to confirm.■ To return to the category select, press .■ To cancel the Category and Channel Searchmode, press and hold .■ Press and hold for about 2 seconds to memorize the current channel.■ Press briefly to recall memorized channel.Channel Scan1 Press and hold to start Channel Scan.Every receivable channel is checked for 10seconds.2 Press to receives the current channel.Direct Access Tuning using theremote controller (RC-405)1 Press DIRECT to enter Direct AccessTuning mode.“– – –” appears.2 Press the number buttons to enter thechannel number.3 Press 4 / +¢ to search for thechannel.■ To cancel the Direct Access Tuning mode,press .■ If you make no button operation for 10seconds, the Direct Access Tuning mode isautomatically canceled.■ If you cannot receive any signal in the inputChannel due to bad conditions on radiowave or other such problems, “ACQUIRINGSIGNAL”/ “NO SIGNAL” appears.Using the remote controller (RC-405)#FM+ : Selects band.4 / +¢ : Selects channel.1 – 6 : Selects preset channel.Preparation : Only with the optional accessory Satellite radio tuner connected.