Kenwood KDC-X500 Instruction Manual

Also see for KDC-BT565U: Instruction manual

Kenwood KDC-X500 Instruction Manual Manual pdf 32 page image

28TROUBLESHOOTING SPECIFICATIONSTunerFM Frequency Range 87.9 MHz — 107.9 MHz(200 kHz space)Usable Sensitivity(S/N = 26 dB)8.2 dBf (0.71 μV/75 Ω)Quieting Sensitivity(DIN S/N = 46 dB)17.2 dBf (2.0 μV/75 Ω)Frequency Response(±3 dB)30 Hz — 15 kHzSignal-to-Noise Ratio(MONO)64 dBStereo Separation (1 kHz) 40 dBAM Frequency Range 530 kHz — 1 700 kHz (10 kHz space)Usable Sensitivity(S/N = 20 dB)29 dBμ (28.2 μV)CD playerLaser Diode GaAIAsDigital Filter (D/A) 8 times over samplingSpindle Speed 500 rpm — 200 rpm (CLV)Wow & Flutter Below measurable limitFrequency Response (±1 dB) 20 Hz — 20 kHzTotal Harmonic Distortion(1 kHz)0.01 %Signal-to-Noise Ratio (1 kHz) : 110 dB/ :105 dBDynamic Range 90 dBChannel Separation 85 dBSymptom RemedyBluetooth®Echo or noise is heard duringa phone conversation.• Adjust the microphone unit’s position. ( 15)• Check the [ECHO CANCEL] setting. ( 17)Phone sound quality ispoor.• Reduce the distance between the unit and the Bluetooth device.• Move the car to a place where you can get a better signalreception.Voice calling method is notsuccessful.• Use voice calling method in a more quiet environment.• Reduce the distance from the microphone when you speak thename.• Make sure the same voice as the registered voice tag is used.Sound is being interruptedor skipped during playbackof a Bluetooth audio player.• Reduce the distance between the unit and the Bluetooth audioplayer.• Turn off, then turn on the unit and try to connect again.• Other Bluetooth devices might be trying to connect to the unit.The connected Bluetoothaudio player cannot becontrolled.• Check whether the connected Bluetooth audio player supportsAudio/Video Remote Control Profile (AVRCP). (Refer to theinstructions of your audio player.)• Disconnect and connect the Bluetooth player again.“DEVICE FULL” The number of registered devices has reached its limit. Retry afterdeleting an unnecessary device. ( 19, DEVICE DELETE)“N/A VOICE TAG” Make sure the same voice as the registered voice tag is used.“NOT SUPPORT” The connected phone does not support Voice Recognition feature orphonebook transfer.“NO ENTRY” / “NO PAIR” There is no registered device connected/found via Bluetooth.“ERROR” Try the operation again. If “ERROR” appears again, check if thedevice supports the function you have tried.“NO INFO” / “NO DATA” Bluetooth device cannot get the contact information.“HF ERROR XX” /“BT ERROR”Reset the unit and try the operation again. If this does not solve theproblem, consult your nearest service center.