|
18 | KDC-X592/ KDC-MP538UBasic OperationSelecting Satellite Radio sourcePress the [SRC] button.Select the “SAT”/ “SIRIUS”/ “XM” display.For how to select source item, refer to Source Select button> of (page4).⁄• You need to register to the service provider to receivethe service by Satellite Radio. Consult the serviceprovider if “CALL … TO SUBSCRIBE” appears.• The radio may take a little time to start receiving afteryou select the Satellite Radio source.• If the signal reception fails, “Acquiring Signal”/ “No Signal”appears.Switching Seek ModePress the [AUTO] button.Display Operation“Channel” Normal manual seeking control.“Preset” Search in order of the channels in the Preset memory.Select the channelPush the Control knob towards right or left.Selecting the Preset BandPush the Control knob toward up.Each time you push the knob, the preset bandalternates between the SR1, SR2, SR3 and SR4.Channel ScanPress the [AUTO] button for at least 2 seconds.Pressing this button for 2 seconds or longer allowsyou to check individual channel for 10 secondseach. Pressing this button again for 2 seconds orlonger allows you to exit this mode.Satellite Radio tuner control (Optional)Category and Channel SearchSelecting the channel and category you want toreceive.1 Enter Category and Channel Search modePress the Control knob.2 Select the CategoryPush the Control knob towards up or down.3 Select the ChannelPush the Control knob towards right or left.Cancelling Category and Channel Search modePress the Control knob.⁄• You cannot Channel search until the categoryinformation is acquired.Function of remote controlDirect Access TuningEntering the channel and tuning.1 Enter Direct Access Tuning modePress the [DIRECT] button on the remotecontrol.2 Enter the channelPress the number buttons.3 Do Channel SearchPress the [4] or [¢] button.Cancelling Direct Access TuningPress the [DIRECT] button on the remotecontrol.⁄• If you make no button operation for 10 seconds, theDirect Access Tuning mode is automatically canceled.• If you cannot receive any signal in the input Channel dueto bad conditions on radio wave or other such problems,“Acquiring Signal”/ “No Signal” appears.
|
