Kenwood KDC-X702 Instruction Manual

Kenwood KDC-X702 Instruction Manual Manual pdf 40 page image

36TROUBLESHOOTING REFERENCESMaintenanceCleaning the unitWipe off dirt on the faceplate with a dry silicone or soft cloth.Cleaning the connectorDetach the faceplate and clean the connectorgently with a cotton swab, being careful not todamage the connector.Handling discs• Do not touch the recording surface of the disc.• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.• Do not use any accessories for the disc.• Clean from the center of the disc and move outward.• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.• When removing discs from this unit, pull them out horizontally.• Remove burrs from the center hole and disc edge before inserting a disc.More informationFor: – Latest firmware updates and latest compatible item list– KENWOOD original application– Any other latest informationVisit .General• This unit can only play the following CDs:• For detailed information and notes about the playable audio files, visit.Connector (on the reverseside of the faceplate)Symptom RemedyBluetooth®“DEVICE FULL” The number of registered devices has reached its limit.Retry after deleting an unnecessary device. ( 25,DEVICE DELETE)“N/A VOICE TAG” Make sure the same voice as the registered voice tag is used.“NOT SUPPORT” The connected phone does not support Voice Recognitionfeature or phonebook transfer.“NO ENTRY”/“NO PAIR” There is no registered device connected/found via Bluetooth.“ERROR” Try the operation again. If “ERROR” appears again, check ifthe device supports the function you have tried.“NO INFO”/“NO DATA” Bluetooth device cannot get the contact information.“HF ERROR XX”/“BT ERROR”Reset the unit and try the operation again. If this does notsolve the problem, consult your nearest service center.“SWITCHING NG” The connected phones might not support phone switchingfeature.ENGLISH