English | 15Installing theMicrophone unit Check the installation position of themicrophone (Accessory 5). Clean the installation surface. Install the microphone. Lay the cable up to the unit with itsecured at several positions using tapeor the like.<t Install the microphone as far as possiblefrom the cell phone.Fix the cable with a commercial item of tape.Accessory5Remove the separator ofthe microphone, and stickthe microphone to theplace shown above.Adjust the direction of themicrophone to the driver.AppendixAbout Audio filet Playable Audio filesAAC-LC (.m4a), MP3 (.mp3), WMA (.wma),WAV (.wav) of USB devicet Playable disc mediaCD-R/RW/ROMt Playable disc file formatsISO 9660 Level 1/2, Joliet, Long file name.t Playable USB devicesUSB mass storage classt Playable USB device file systemsFAT12, FAT16, FAT32The online manual aboutaudio files is put on the site,www.kenwood.com/cs/ce/audiofile/.Models of iPods/iPhones that canbe connected to this unitMade fort iPod touch (4th generation)t iPod touch (3rd generation)t iPod touch (2nd generation)t iPod touch (1st generation)t iPod classict iPod with videot iPod nano (6th generation)t iPod nano (5th generation)t iPod nano (4th generation)t iPod nano (3rd generation)t iPod nano (2nd generation)t iPod nano (1st generation)t iPhone 4St iPhone 4t iPhone 3GSt iPhone 3Gt iPhoneFor information on the compatibility withiPod/iPhone software, visit www.kenwood.com/cs/ce/ipod/.KDC-X997, KDC-BT955HD, KDC-X897,KDC-BT855U only