| 
English | 31Audio Preset RecallRecalling the sound setup registered by Preset Memory> (page 31).1 Select the sourcePress the [SRC] button.2 Enter Audio Preset Recall modePress [ ] 1 sec., and select “DSP” > “PRESET”>“RECALL”.Press the [AUD] knob for at least 1 second.• For how to select Function Control items, refer to (page 10).3 Select the number to recall in the memoryTurn the [AUD] knob to select number, and thenpress the [AUD] knob.“USER1” – “USER6”4 Recall the Audio PresetTurn the [AUD] knob to select “YES”, and thenpress the [AUD] knob.“COMPLETE” is displayed.5 Exit Function Control modePress the [ ] button for at least 1 second.⁄• The User memory of (page 27)is changed to the value which was recalled.• The source tone memory item of Select> (page 27) is changed to the value which wasrecalled by the selected source.Audio Preset MemoryRegistering the value setup by Sound Control.1 Setup Sound ControlRefer to the following operations to setup theSound Control.- Cabin selection (page 29)- Speaker Setting (page 29)- DTA (Digital Time Alignment) setting (page 30)- X’Over setting (page 30)- Preset Equalizer Select (page 27)- Manual Equalizer Control (page 28)- Position Control (page 28)2 Enter Audio Preset Memory mode (Other thanStandby mode)Press [ ] 1 sec., and select “DSP” > “PRESET” >“MEMORY”.Press the [AUD] knob for at least 1 second.• For how to select Function Control items, refer to (page 10).3 Select the number to put in the memoryTurn the [AUD] knob to select number, and thenpress the [AUD] knob.“USER1” – “USER6”4 Put the Audio Preset in the memoryTurn the [AUD] knob to select “YES”, and thenpress the [AUD] knob.“COMPLETE” is displayed.5 Exit Function Control modePress the [ ] button for at least 1 second.⁄• Register 6 pairs of Audio Preset Memory.• “USER1”: When you press the Reset, all the sources willbe the setting value which is registered.• “USER1”, “USER2”:The memory cannot be erased by the Reset button.• This function cannot be registered when the iPodEqualizer set in (page 27). |
