• Whilst the control panel is moving, pressing the buttons will nothave any effect. Do not try to press the buttons on the controlpanel as the faceplate is moving, as excessive force maydamage the unit.• During the forced closing of the unit (i.e., having the unit leftclosed whilst ignition is turned on), the faceplate will not openno matter how often the ignition is turned on or off, unless“Manual Open Switch” at the rear of the faceplate is pressed inorder to open it. You can prevent tampering of the unit whenletting someone else drive your car by keeping it closed thisway.To cancel the forced closing of unit and open control panel:Slide the Manual open switch, as illustrated below, for as manytimes as you have preset in the "Manual Open Switch Setting(Open SW#)" in the menu.When you set the Manual Open Switch setting to 2 or 3, slide themanual open switch successively. If you do not slide the switchsuccessively, this cannot be verified correctly.Manual open switchNOTEYou can help prevent theft of the unit by reversing the faceplateso that the control panel cannot be seen, hiding the unit, andshutting off the audio.Power ON/OFF:When you turn your vehicle’s ignition on, the unit’s power willalso turn on, with the faceplate reversing to show the controlpanel.When you turn your vehicle’s ignition off, the faceplate willreverse to hide the control panel, and the unit’s power will turnoff.• After installation of your Mask unit, be sure to transmit the"Mask Key's" signal to deactivate the demonstration mode.If this procedure is not carried out, the control panel of the unitwill re-open in two seconds even with your vehicle's ignitionturned off.• When the control panel of the faceplate is hidden, the unit willbe locked by the sleeve, making it more difficult to remove theunit.• When the moving faceplate is hit by an object, it will stop andreturn to its original state. Remove the object and repeat theaction.Using the Unit in Vehicles with Covered Consoles• Make sure the console is uncovered whilst the faceplate isreversed.• Do not exert any excess force on the movable parts of the unit,including the faceplate, as it can cause failure in the unit’smechanism.Hiding the unit with the ignition turned on (forced closing):Hold down the SRC button for one second or more.The faceplate will reverse, hiding the unit. The unit will turnoff.• When the closing faceplate is hit by an object, the unit will turnoff without the faceplate closing all the way. Remove the objectand press the SRC button to turn the unit back on, then turn itoff again to make it close properly.NOTE2CAUTIONNOTEPowerBasic operations— 6 —English