Kenwood KMM- BT508DAB Instruction Manual

ENGLISH 25[BALANCE] [L15] to [R15] ([0]): Adjusts the left and right speaker output balance.[VOLUME OFFSET] [–15] to [+6] ([0]): Presets the initial volume level of each source bycomparing to the FM volume level.(Before adjustment, select the source you want to adjust.)[SOUND EFFECT][SOUND RECNSTR](Soundreconstruction)(Not applicable for RADIO source, DIGITAL AUDIO source and AUXsource.)[ON]: Creates realistic sound by compensating the high-frequencycomponents and restoring the rise-time of the waveform that are lost inaudio data compression. ; [OFF]: Cancels.[SPACE ENHANCE] (Not applicable for RADIO source and DIGITAL AUDIO source.)[SML]/[MED]/[LRG]: Virtually enhances the sound space. ;[OFF]: Cancels.[SND REALIZER] [LV1]/[LV2]/[LV3]: Virtually makes the sound more realistic. ;[OFF]: Cancels.[STAGE EQ] [LOW]/[MID]/[HI]: Virtually adjusts the sound position heard from thespeakers. ; [OFF]: Cancels.[DRIVE EQ] [ON]: Boosts the frequency to reduce the noise heard from outside thecar or running noise of the tyres. ; [OFF]: Cancels.[SPEAKER SIZE] Depending on the crossover type you have selected (see “Change thecrossover type” on page 6), 2-way crossover or 3-way crossoversetting items will be shown. (See the following “Crossover settings”.)By default, 2-way crossover type is selected.[X ‘ OVER][DTA SETTINGS] For settings, see “Digital Time Alignment settings” on page 27.[CAR SETTINGS]• For 2-way crossover: [SUB-W LEVEL]/[SUBWOOFER SET] is selectable only if[SWITCH PREOUT] is set to [SUB-W]. (Page 5)• [SUB-W LEVEL] is selectable only when [SUBWOOFER SET] is set to [ON].(Page 24)Audio SettingsCrossover settingsBelow are the available setting items for 2-way crossover and 3-waycrossover.SPEAKER SIZESelects according to the connected speaker size for optimum performance.• The frequency and slope settings are automatically set for the crossover ofthe selected speaker.• If [NONE] is selected for the following speaker in [SPEAKER SIZE], the [X ‘ OVER]setting of the selected speaker is not available.– 2-way crossover: [TWEETER] of [FRONT]/[REAR]/[SUBWOOFER]– 3-way crossover: [WOOFER]X ‘ OVER (crossover)• [FRQ]/[F-HPF FRQ]/[R-HPF FRQ]/[SW LPF FRQ]/[HPF FRQ]/[LPF FRQ]: Adjusts thecrossover frequency for the selected speakers (high pass filter or low passfilter).If [THROUGH] is selected, all signals are sent to the selected speakers.• [SLOPE]/[F-HPF SLOPE]/[R-HPF SLOPE]/[SW LPF SLOPE]/[HPF SLOPE]/[LPF SLOPE]:Adjusts the crossover slope.Selectable only if a setting other than [THROUGH] is selected for thecrossover frequency.• [SW LPF PHASE]/[PHASE]: Selects the phase of the speaker output to be in linewith the other speaker output.• [GAIN LEFT]/[GAIN RIGHT]/[F-HPF GAIN]/[R-HPF GAIN]/[SW LPF GAIN]/[GAIN]: Adjuststhe output volume of the selected speaker.