Kenwood KNA-G510 Installation Manual

Also see for KNA-G510: Training guide Instruction manual Installation manual Instruction manual Instruction manual

Contents

specifications

EnglishWhat’s IncludedGPS antenna andmetal platemain unit screws (4) wiring harness hook and loopfasteners (2)Installing the main unitUse the screws or the hook and loop fasteners provided to mount the main unit in the vehicle. Select a location that allowsyou to access the unit’s SD card slot.Caution• Do not install the unit where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills, orliquids. Use only the screws provided. If you use the wrong screws, you could damage the unit.• Check for cables or other parts underneath the floor mat before cutting the floor mat.Installing the GPS antennaCaution• Do not paint the antenna. This will impair or disable signal reception.• Remove any object or accumulated snow, etc., from the top of the antenna. It will reduce reception strength.• Do not pull the cord when removing the antenna or adjusting its position. This can cause a short or snap the wires.• The permanent adhesive on the back of the metal plate is extremely difficult to remove after it is installed.The GPS antenna can be installed either inside or outside the vehicle. It should be placed horizontally for best GPSreception. The GPS antenna must have a clear view of the sky. If you install the antenna inside the vehicle, place itclose to a window; GPS signals can pass through glass but not through metal. Refer to the image on the next page forrecommended places to install the antenna. Place the GPS antenna on a metallic surface, such as the roof of your vehicle,for best reception. If a metallic surface is not available, mount the GPS antenna to the enclosed metal plate. See the nextpage for further instructions.Installing optional accessoriesThe optional XM Smart Antenna (such as the GXM 30) can be placed inside or outside the vehicle. Like the GPSantenna, it must have a clear view of the sky. If you use an extension cable with the XM antenna, wrap the two connectorswith electrical tape. For information on installing the optional FM traffic receiver (such as the GTM 10), refer to theInstallation Guide included with the traffic receiver.