Kenwood KNA-NT100 Installation Manual

KENWOOD AGARMIN®KNA-NT100 Traffic ReceiverInstallation Manual! WARNINGSee the Safety Precautions and Important Information in the Instruction Manual for your Kenwood NavigationSystem for product warnings and other important information.This product, its packaging, and its components contain chemicals known to the State of California to cause cancer,birth defects, or reproductive harm. This Notice is being provided in accordance with California's Proposition 65.If you have any questions or would like additional information, please refer to our Web site at www.garmin.com/prop65.NOTICEFor the best performance, it is critical that the unit receives a strong FM signal. Professional installation isrecommended. Installation of the KNA-NT 100 by someone other than a professional installer may damage the unitand void the warranty.To properly receive all KNA-NT 100 content, verify that the latest software version is installed on your KenwoodNavigation System. See www.garmin.com/kenwood for the software updating procedure.KNA-NT100 OverviewThe KNA-NTI 00 has two cable connectors that allow it to be installed in series between the antenna andKenwood unit. Do not open the KNA-NTIOO or loosen the case screws.In: In from the antenna. Connect the antenna adapter here.Out: Out to the Kenwood unit. Connect the Kenwood unit adapter cable here.LED: Displays the signal status.Mini-USB cable: 1.5-meter built-in cable to connect to a Kenwood unit.Out InBefore InstallationLEDNOTICEDo not install the KNA-NTIOO where it will be exposed to direct sunlight, excessive heat or humidity, dust, spills,or liquids.Carefully read this installation sheet and follow the instructions to install the KNA-NTIOO in the vehicle. Do notopen the KNA-NTIOO or loosen the case screws.EN-1 864-4754-08

/ 4

Related manuals for Kenwood KNA-NT100