Kenwood KRC-435 Instruction Manual

Also see for KRC-435: Service manual Instruction manual

n InstallationFrrewall or metal supportScrew fM4X8)(commercrallyava!lable)n Installing in Japanese-Made Cars1 Refer to the section “Removing the hard rubber frame” (page 26)and then remove the hard rubber frame.2 Align the holes in the unit (two locations on each side) with thevehicle mounting bracket and secure the unit with the accessoryscrews.Bend the tabs of themountina sleevewrth a screwdriver or/ \ simrlar utensil andSelf-tapping screw Metal mountrng strap attach It rn place.fcommercrally avariable) fcommercrally avariable)T Toyota carsN: Nissan cars\AccessoryGj for Nrssan carAccessory@ .for Toyota carA l During installation, do not use any screws except for those providedThe use of different screws might result rn damage to the mart- unrtl Damage may occur If a screwdriver or srmrlar tool IS used withexcessrva force durrng the rnstallatrons.Make sure that the unrt IS Installed securely rn place. If the unit ISunstable, rt may malfunctron (for example, the sound may skip)W Screwing the Faceplate on the UnitIf you want to fasten thefaceplate to the main unit sothat It does not fall off,screw in the provrdedscrews (04 X 16 mm) in theholes shown below.ANever Insert the taptrte screw (04 x 16 mm) rn any other screw holethan the one specrfled. If you screw it rn another hole, it wrll contactand may cause damage to the mechanrcal parts Inside the unit- 25 -