Kenwood KRF-V5050D Instruction Manual

Also see for KRF-V5050D: Instruction manual Instruction manual Service manual Service manual

22Operations 1 Use the INPUT SELECTOR to select the source (CD, DVD, orVIDEO2) you want to record.2 Set the cassette deck or MD to record.3 Press and hold the DIMMER key for more than 2 seconds toselect the A-REC or M-REC mode.1 Rec mode off : The digital input record mode isswitched off.2 A-REC : The digital input signals (DTS, DolbyDigital, or PCM) are identified auto-matically and converted into stereosignals that are ready for recording.3 M-REC : The input signal type at the momentthis mode is selected is held through-out this mode.Recording audio (digital sources)Switch on the REC mode to record a digital input source.Usually use the A-REC (Auto-Record) mode to record audio inputsources. When the digital mode changes during recording in the A- RECmode, the audio input source may be interrupted momentarily. 4 Start playback, then start recording.RecordingRecording video1 Use the INPUT SELECTOR to select the video source (other than“VIDEO1”) you want to record.2 Set the video deck connected to VIDEO 1 to record.• Select the REC MODE to record a digital input source.3 Start playback, then start recording.• Recording may not be normal for some video software. This is due tothe copy guard condition. °Recording music in A-REC or M-REC modeINPUT SELECTORDIMMER• If the audio reproduction stops in the middle due to change in theinput signals, etc., press the DIMMER key.• The mode changes every 2 seconds as shown below.For A-REC mode:DIGITALAUTO SOUNDFMAMMHzkHz3DOWN MIXS.DIRECTMONITORDSPMEMOST.TUNEDAUTOPRO LOGICDIGITALAUTO SOUNDFMAMMHzkHz3DOWN MIXS.DIRECTMONITORDSPMEMOST.TUNEDAUTOPRO LOGICSTEREOSTEREODIGITALAUTO SOUNDDIGITALAUTO SOUNDGITAL AUDIGITALGITAL AUTDIGITALFor M-REC mode:FMAMMHzkHz3DOWN MIXS.DIRECTMONITORDSPMEMOST.TUNEDAUTOPRO LOGICFMAMMHzkHz3DOWN MIXS.DIRECTMONITORDSPMEMOST.TUNEDAUTOPRO LOGICSTEREOSTEREODIGITALAUTO SOUNDAUTO SOUNDDIGITALAUTO SOUNDAUTO SOUND