Kenwood KRF-V7771D Service Manual

Also see for KRF-V7771D: Instruction manual Instruction manual Setup Instruction manual Service manual

Contents

663449933211121435 x29 x58 x23 x271313 131414151012221x32 x322x2x52 x22333313x29[Remove the bottom plate.]Make use of the changing final transistor etc.1. Remove the 19 screws (1, 2) and PCB support, thenremove the bottom plate.[Check the vertical PCB]1. (Exist bottom plate) Remove the hook of rearpanel(1).2. Remove the 29(Exist bottom plate: 34)screws(2), then remove the rear panel.3. Connect the GND of the phono terminal, theGND of antenna shield board,the GND ofcoax., the GND of system control shieldboard, the GND of SP terminal shield boardand the chassis with 5 wires connected alli-gator chips(3).[Remove the escutcheon (operationpanel)]1. Remove the knob(1), the nut (2), the 11screws(3, 4, 5) and 2 hooks (6), thenremove the front panel ass'y.2. Remove the lead wire(7), the 2 screws(8 :except K,P type) and 7 screws(9) thenremove the PCB.3. Remove the under front glass(0, -), thenremove the front panel(=) from the subpanel.4. Remove the 2 under escutcheon sides(~) by· screw driver and the 2 hooks(!) thenremove the escutcheon(@).Fig. 3Fig. 1Fig. 2KRF-V7771D/V8881D/VR-2080/20905DISASSEMBLY FOR REPAIRwww. xiaoyu163. comQQ 376315150 992894298TEL 13942296513 992894298051513673QQTEL 13942296513 QQ 376315150 892498299TEL 13942296513 QQ 376315150 892498299