ENGLISH4 ENInstallation MethodsOn the Desktop or ShelfPlace the speaker on the desktop, shelf or a similar level surface.On the WallThe speaker include mount holes for wall mounting.1. Screw a single screw into the wall at the desired loca-tion. Screw it only part way in, so that the screwprojects 8 to 10 mm (5/16 to 3/8 inches) outward fromthe wall surface.2. Hang the speaker by fitting the top mount hole (at theupper rear of the speaker) over the extending part ofthe screw. Confirm that the speaker is held firmly andsecurely in place.On the speaker standThe speaker can be installed on the SR-8000 stand optionally available from KENWOOD.Attaching the cushionsAttach cushions to the base of the speaker as shown be-low. The cushions prevent the speaker from sliding, anddampen its vibrations.PrecautionsPlease observe the following precautions when mounting speaker onto the wall.• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 0.6 kg [1.3 lb]).• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and thatare long enough to provide sufficient strength.• If you are uncertain about the wall’s support strength, the type of screw to use, or any other points regarding this type ofinstallation, please consult a contractor or other qualified person before proceeding.Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injuryor damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficientsupport strength.8 - 10 mm(5/16 - 3/8”)