Kenwood KS-3200HT Instruction Manual

Also see for KS-3200HT: Istruzioni per l'uso

Contents

Kenwood KS-3200HT Instruction Manual Manual pdf 4 page image

ENGLISH4 ENInstallation MethodsOn the Desktop or ShelfPlace the speakers on the desktop, shelf or a similar level surface.The KS-5200HT and KS-5200EX are supplied with the speaker stands for the front speakers. Refer to the separate instructionmanual for the speaker stands when installing the speakers using the stands.On the WallThe speakers include mount holes for wall mounting. You can hang the front and surround speakers on the wall vertically, and thecenter speaker horizontally.7 Front speaker , Surround speaker1. Screw a single screw into the wall at the desired loca-tion. Screw it only part way in, so that the screw projects8 to 10 mm (5/16 to 3/8 inches) outward from the wallsurface.2. Hang the speaker by fitting the top mount hole (at theupper rear of the speaker) over the extending part ofthe screw. Confirm that the speaker is held firmly andsecurely in place.7 Center speaker1. Screw two screws into the walls 150 mm (5-7/8 inches)apart, making sure that screws are horizontally level.Screw each screw only part way in, so that the screwprojects 8 to 10 mm (5/16 to 3/8 inches) outward fromthe wall surface.2. Hang the speaker by fitting the two mount holes (at therear of the speaker) over the extending part of the screw.Confirm that the speaker is held firmly and securely inplace.Various mounting methods7 On the optional kenwood stand (SR-8000)(front speaker and surround speaker only)The speaker can be installed on the SR-8000 stand optionallyavailable from KENWOOD.7 On the commercially available speaker mount or bracket(front speaker only)Any commercially available speaker mount or bracket can alsobe used (provided that the speaker can be fixed using an M5screw with a pitch of 60 mm andeffective thread length of 10 to 13mm).For details, read the instructionmanual for the speaker mount orbracket.Attaching the cushionsAttach cushions to the base of the speaker as shown below.The cushions prevent the speaker from sliding, and dampenits vibrations.Front speaker, Center speakerSurround speakerPrecautionsPlease observe the following precautions when mounting speakers onto the wall.• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. front speaker : 0.8 kg[1.8 lb], center speaker : 0.8 kg [1.8 lb], surround speaker : 0.6 kg [1.3 lb]).• Wall screws must be purchased separately. Be sure to use screws that are appropriate for the wall you are using, and thatare long enough to provide sufficient strength.• If you are uncertain about the wall’s support strength, the type of screw to use, or any other points regarding this type ofinstallation, please consult a contractor or other qualified person before proceeding.Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injuryor damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficientsupport strength.E ffe c t i ve t h r e a dlengthM5 screw8 - 10 mm(5/16 - 3/8”)150 mm(5-7/8”)8 - 10 mm(5/16 - 3/8”)