Kenwood KSC-256 Instruction Manual

Also see for KSC-256: Service manual

O rientatiOnNote: The battery slots are molded for different model types. The illustration shows theKSC-256.speciFicatiOnsAC Voltages 100 - 240 V ACDimensions (W x H x D) (charger only) 526 x 105 x 203 mm20.7 x 4.1 x 8.0 inchesWeight (charger only) Approx. 3 kg / 106 ozATTENTION: Check the rating label attached to the bottom of the charger for other importantspecifications.charging tips◆ Using the transceiver while charging its battery pack will interfere with correct charging.◆ If the operating time of a battery pack decreases although the battery pack is fully andcorrectly charged, the battery pack life is over. Replace the battery pack.◆ The ambient temperature should be from 0°C to 40°C while charging is in progress.When the ambient temperature is in the upper limits (close to 40°C), the charging time maybecome longer than normal.◆ The charging times provided are obtained when a battery pack discharged to 1 V/cell x 6 (Ni-Cd and Ni-MH) or 3 V/cell x 2 (Li-ion) is charged at normal temperatures. This charging timevaries depending on the degree of discharge and the ambient charging temperature.◆ If the battery pack contacts are not properly mated with the charger terminals, the indicatormay blink red or may remain unlit. To resolve this problem, reinsert the battery pack aftercleaning the battery pack contacts and the charger terminals.◆ Ni-Cd and Ni-MH Only: Repeatedly recharging a fully charged battery pack, or almost fullycharged pack, shortens its operating time. To resolve this problem, use the pack until it iscompletely discharged, 1 V/cell x 6 then recharge the pack to full capacity.◆ Ni-Cd and Ni-MH Only: The battery life in charge/discharge cycles is approximately 300.However, overcharging and excessive discharging shortens the battery pack life.◆ When using this equipment near a radio, transceiver or television, you may experienceinterference with reception.AC inletPlug in the supplied AC cord here.Power switchCharging slotSlide a battery packor a transceiverequipped with abattery pack intothis slot.Tri-color indicatorInforms you of the currentcharger status.Nameplate locationAttach a nameplate stickerin this location, showing themodel name, user name,etc. for the charger slot.