Kenwood KSW-700 Instruction Manual

Contents

Kenwood KSW-700 Instruction Manual Manual pdf 7 page image

EN 7ENGLISHHorizontally1 Screw two screws into the walls 150 mm(5-7/8 inches) apart, making sure that screwsare horizontally level. Screw each screw onlypart way in, so that the screw projects 8 to10 mm (5/16 to 3/8 inches) outward from thewall surface.2 Hang the speaker by fitting the two mountholes (at the rear of the speaker) over theextending part of the screw. Confirm that thespeaker is held firmly and securely in place.Mounting methods (Surround speaker)The speaker can be installed on the SR-8000 standoptionally available from Kenwood.And any commercially available speaker mount orbracket can also be used (provided that the speakercan be fixed using an M5 screw with a pitch of 60 mmand effective thread length of 10 to 13 mm (3/8 to 1/2inches)). For details, read the instruction manual forthe speaker mount or bracket.Effective threadlengthM5 screwUsing speakers on the wall(Surround speaker, Center speaker)The speakers include mount holes for wall mounting.You can hang the surround speakers on the wallvertically, and the center speaker horizontally.Precautions:Please obser ve the following precautions whenmounting speakers onto the wall.• Be sure that the wall you are using is strong enough tosupport the full weight of the speaker (approx. centerspeaker : 0.7 kg [1.5 lb], surround speaker : 0.5 kg [1.1lb]).• Wall screws must be purchased separately. Be sure touse screws that are appropriate for the wall you areusing, and that are long enough to provide sufficientstrength.• If you are uncertain about the wall’s support strength,the type of screw to use, or any other points regardingthis type of installation, please consult a contractor orother qualified person before proceeding.Be sure to follow the procedure given here when carryingout installation. Kenwood can assume no liability forinjury or damage that may occur if a speaker setupfalls from the wall as a result of incorrect installation orinsufficient support strength.Vertically1 Screw a single screw into the wall at thedesired location. Screw it only part way in,so that the screw projects 8 to 10 mm (5/16to 3/8 inches) outward from the wall surface.2 Hang the speaker by fitting the top mounthole (at the upper rear of the speaker) overthe extending part of the screw. Confirmthat the speaker is held firmly and securelyin place.