Kenwood KVT-627DVD Instruction Manual

Also see for KVT-627DVD: Installation manual Installation manual Service manual

Contents

98 | EnglishDisc source? The disc control mode cannot be selected.✔ No wire has been connected to the discchanger input terminal on the unit.Connect the wire to the disc changer inputterminal on the unit.? The specified disc does not play, but anotherone plays instead.✔ The specified CD is quite dirty.Clean the CD.✔ The CD is upside-down.Load the CD with the labeled side up.✔ The disc is loaded in a different slot from thatspecified.Eject the disc magazine and check the numberfor the specified disc.✔ The disc is severely scratched.Try another disc instead.? The sound skips.✔ Something is touching the disc changer.Remove whatever is touching it.✔ The CD is scratched or dirty.If skipping happens at the same place whenthe car is stopped, something with the CD iswrong. Clean the CD.? The display shows that the changer is beingplayed, but no sound can be heard.✔ The computer chip in the unit is notfunctioning normally.Press the reset button on the unit (page 4).? The specified track will not play.✔ Random play or magazine random play hasbeen selected.Turn off random play or magazine randomplay.? Track repeat, disc repeat, track scan, disc scan,random play, and magazine random play startby themselves.✔ The setting is not cancelled.The settings for these functions remain on untilthe setting to off or the disc ejected, even ifthe power is turned off or the source changed.? Can’notremove disc.✔ The cause is that more than 10 minutes haselapsed since the vehicle ACC switch wasturned OFF.The disc can only be removed within 10minutes of the ACC switch being turned OFF.If more than 10 minutes has elapsed, turnthe ACC switch ON again and press the Ejectbutton.MP3/WMA source? Cannot play an MP3/WMA.✔ The media is scratched or dirty.Clean the media, referring to the CD cleaningof the section on (page 15).? The sound skips when an MP3/WMA is beingplayed.✔ The media is scratched or dirty.Clean the media, referring to the CD cleaningof the section on (page 15).✔ The recording condition is bad.Record the media again or use another media.? The MP3/WMA track time is not displayedcorrectly.✔ ---There are times when it isn’t displayed correctlyaccording to the MP3/WMA recordingconditions.? Cannot display the ID3 tag informationcorrectly.✔ Record is not made in conformity with the ID3tag version 1.x.Record in conformity with the ID3 tag version1.x.Also, the display may be incorrect if anMP3/WMA file uses the ID3 tag v1.x standardand if this standard has been expanded afterproduction of the machine software.