Kenwood KVT-729DVD Installation Manual

Also see for KVT-729DVD: Service manual Instruction manual

Contents

10 | KVT-729DVDRemoving Monitor/Player UnitRemoving the Hard Rubber Frame(escutcheon)1. Engage the catch pins on the removal tool 6 andremove the two locks on the lower level.Lower the frame and pull it forward as shown inthe figure.Removal Tool (Accessory 6)Lock Catch⁄• The frame can be removed from the top side in the samemanner.2. When the lower level is removed, remove theupper two locations.Removing the Unit1. Remove the hard rubber frame by referring to theremoval procedure in the section Hard Rubber Frame>.2. Remove the Hex-head screw with integral washer(M4 × 8) on the back panel.3. Insert the two removal tools 6 deeply into theslots on each side, as shown.Removal Tool(Accessory 6)4. Lower the removal tool toward the bottom, andpull out the unit halfway while pressing towardsthe inside.⁄• Be careful to avoid injury from the catch pins on theremoval tool.5. Pull the unit all the way out with your hands, beingcareful not to drop it.

/ 12

Related manuals for Kenwood KVT-729DVD