Kenwood LS-X50 Instruction Manual

Contents

Kenwood LS-X50 Instruction Manual Manual pdf 4 page image

ENGLISH4 ENOn the WallThis speaker include mount hole for wall mounting. You use only one screw. Proceed as follows.PrecautionsPlease observe the following precautions when mounting speakers onto the wall or speaker stand.• Be sure that the wall you are using is strong enough to support the full weight of the speaker (approx. 2.6 kg [5.7 lb] ).• Wall screw must be purchased separately.• Be sure to use a screw that is appropriate for the wall or stand you are using, and that are long enough to providesufficient strength.• If you are uncertain about the wall’s support strength, the type of screw to use, or any other points regarding thistype of installation, please consult a contractor or other qualified person before proceeding.Be sure to follow the procedure given here when carrying out installation. Kenwood can assume no liability for injuryor damage that may occur if a speaker setup falls from the wall as a result of incorrect installation or insufficientsupport strength.1 Screw a single screw into the wall at the desired loca-tion. Screw it only part way in, so that the screwprojects 9 to 11 mm (3/8 to 7/16 inches) outward fromthe wall surface.On Floor or ShelfPlace the speakers on the floor or on a shelf or other horizontalstable surface. Keep in mind that speakers are not fixed intoplace, so be careful to avoid knocking them over.• Attach four cushions to the base of thespeaker, one at each corner. The cush-ions prevent the speaker from sliding,and dampen its vibrations.3 The mount hole for wall mounting is provided on the lower rear of the speaker. Place the speaker upside down andhook the hole on the screw attached to the wall. Confirm that the speaker is held firmly and securely in place.2 Remove the grille and reattach it upside down.• Attach each couple of provided cushions to make twosets of two-cushion piles, and attach them to the twopositions shown on the rear of the speaker. These pileswill protect the speaker body from damage and pre-vent the vibrations of the speaker body from beingtransmitted to the wall.On the speaker standThe speaker can be installed on the SR-8000 stand optionally available from KENWOOD. Anycommercially available speaker mount or bracket can also be used (provided that the speakercan be fixed using an M5 screw with a pitch of 60 mm and effective thread length of 7 to 10mm). For details, read the instruction manual for the speaker mount or bracket.Installation Methods9 - 11 mm (3/8 to 7/16”)Mount holeCushionEffective threadlengthM5 screwCushion• Wall screw must be purchased separately.