8 | EnglishAccessories1..........12..........13..........24..........15..........16..........1Accessories/ Installation ProcedureInstallation Procedure1. To prevent short circuits, remove the key fromthe ignition and disconnect the · terminal ofthe battery.2. Make the proper input and output cableconnections for each unit.3. Connect the wiring harness wires in thefollowing order: ground, ignition.4. Connect the wiring harness connector to theunit.5. Install the unit in your car.6. Reconnect the · terminal of the battery.7. Press the reset button. (page 3)2 WARNING• This product is intended for use with 12V DC negativeground power only. Do not connect it to any otherpower supply.• To prevent shorting, disconnect the battery cable fromthe negative terminal of the battery during installation.• Be sure to firmly stabilise this product. Do not install it ina location which is not stable.• Follow the installation and wiring procedures describedin this manual. Improper wiring or modified installationcan not only result in malfunction or damage to the unitbut may also result in an accident.• If your car’s ignition does not come with an ACC position,connect the ignition wires to a power source that can beturned on and off with the ignition key. If you connectthe ignition wire to a power source that receives aconstant voltage supply, as with battery wires, the batterymay die.• If the fuse blows, first make sure that the wires have notcaused a short circuit, then replace the old fuse with onewith the same rating.• Do not let unconnected wires or terminals touch metalon the car or anything else conducting electricity. Toprevent short circuits do not remove the caps fromunused terminals or from the ends of the unconnectedwires.• After the unit is installed, check whether the brake lamps,blinkers, wipers, etc. on the car are working properly.• Insulate unconnected wires with vinyl tape or othersimilar material.• Thoroughly wipe away oil and other dirt from theinstallation surface.Please avoid installation on uneven surfaces.• Do not install the Hideaway Unit under the carpet.Otherwise heat build-up occurs and the unit may bedamaged.(Ø4 × 16 mm)