Kenwood NV-701 Instruction Manual

Also see for NV-301: Service manual

Contents

Kenwood NV-701 Instruction Manual Manual pdf 35 page image

35Basic section4. Select the source to be recorded. (Except for TAPEinput)The input source component tobe recorded should be displayed.÷ If a disc has already been loaded when the CD input is selected, it starts toplay automatically. In this case, press the 7 (stop) key to stop it.÷ When you select VIDEO/6ch IN (NV-701 only) or MD/DVD (NV-301 only) torecord the external input, adjust the input level. QSelect CD, TUNER, or MD/DVD(NV-301 only) or VIDEO/6ch IN(NV-701 only) input for the source.1 Start recording.2 Play (or tune) the input source to be recorded.5. Start recording.÷ If a disc has already been loadedwhen the CD input is selected, itwill starts recording automatically.÷ Recording stops automaticallywhen the tape side(s) to be re-corded have been fully recorded.÷ Press the stop (7) key of the cas-sette deck unit to stop recording(see the next page).LightsLet's recordTo pause recording (Main unit only)÷ Pressing the SET (¶) key pauses recording afterleaving a non-recorded space of about 4 seconds.÷ If the key is pressed again in less than 4 seconds after ithas been pressed, recording resumes from that instant.LightsSET44CDTUNERTAPEVIDEO/6ch INBANDCDTUNERTAPEMD/DVDBANDPress the desired key.SET55SWRECRLNV-301 NV-701C D 0 1 0 : 0 2• SWRECRL(SW channel lightsfor NV-701 only)(SW channellights forNV-701 only)