NX-700-K FCC ID: K44378600 / IC: 282F-378600NX-800-K FCC ID: K44378700One or more of the following statements may be applicable:FCC WARNINGThis equipment generates or uses radio frequency energy. Changes or modifications to this equipment may causeharmful interference unless the modifications are expressly approved in the instruction manual. The user could losethe authority to operate this equipment if an unauthorized change or modification is made.packing instructions are for use by your KENWOOD dealer, an authorized KENWOOD serviceUNPACKING AND CHECKING EQUIPMENTNote: The following unfacility, or the factory.Carefully unpack the transceiver. We recommend that you identify the items listed in the following table beforediscarding the packing material. If any items are missing or have been damaged during shipment, file a claim with thearrier immediately.Ƈ Supplied AccessoriesQuantitycItem Part NumberMicrophone (with cable) T91-0639-xx 1Microphone hanger J19-1584-xx 1DC power cable•Fuse (15A)E30-7523-xxF52-0024-xx12Mounting bracket J29-0726-xx 1Screw Set:•5 x 16 mm self-tapping screw (4pieces)•Hex-headed screw with washer (4 pieces))•Flat washer (4 pieces)N99-xxxx-xx 1•Spring washer (4 piecesInstruction Manual B62-××××-×× 1INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BY THE FCCThis equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in aresidential installation.This equipment generates, uses and can generate radio frequency energy and, if not installed and used inaccordance with the instructions, may cause harmful interference to radio communications.However, there is no guarantee that the interference will not occur in a particular installation. If this equipment doescause harmful interference to radio or television reception, which can be determined by turning the equipment offand on, the user is encouraged to try to correct the interference by one or more of the following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.• Consult the dealer for technical assistance.