55CAUTIONSPlease observe the following cautions to prevent fire,personal injury, and transceiver damage:• Do not attempt to configure your transceiver whiledriving; it is too dangerous.• Be aware of local laws pertaining to the use ofheadphones/headsets while driving on publicroads. If in doubt, do not wear headphones whilemobiling.• Do not modify this mobile controller unlessinstructed by this manual or by other KENWOODdocumentation.• Do not expose the mobile controller to long periodsof direct sunlight nor place it close to heatingappliances.• Do not place the mobile controller in excessivelydusty, humid, or wet areas, nor on unstablesurfaces.• If an abnormal odor or smoke is detected comingfrom the mobile controller or transceiver, turn OFFthe power immediately. Contact a KENWOODservice station or your dealer.• The mobile controller is designed only to work withcompatible KENWOOD transceivers. Neverattempt to connect the mobile controller to othertransceivers.NOTICES TO THE USEROne or more of the following statements may beapplicable:FCC WARNINGThis equipment generates or uses radio frequency energy. Changes ormodifications to this equipment may cause harmful interference unlessthe modifications are expressly approved in the instruction manual. Theuser could lose the authority to operate this equipment if an unauthorizedchange or modification is made.INFORMATION TO THE DIGITAL DEVICE USER REQUIRED BYTHE FCCThis equipment has been tested and found to comply with the limits for aClass B digital device, pursuant to Part 15 of the FCC Rules. Theselimits are designed to provide reasonable protection against harmfulinterference in a residential installation.This equipment generates, uses and can generate radio frequencyenergy and, if not installed and used in accordance with the instructions,may cause harmful interference to radio communications. However,there is no guarantee that the interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipmentoff and on, the user is encouraged to try to correct the interference byone or more of the following measures:•Reorient or relocate the receiving antenna.•Increase the separation between the equipment and receiver.•Connect the equipment to an outlet on a circuit different from that towhich the receiver is connected.•Consult the dealer for technical assistance.When condensation occurs inside the controller:Condensation may occur inside the controller in such cases where theroom is warmed using a heater on cold days or where the controller isquickly moved from a cold room to a warm room. When condensationoccurs, the microcomputer and/or other circuits may become unstable,resulting in transceiver malfunction. If this happens, unplug the controllerand wait for a while. When the condensed droplets disappear, thecontroller will function normally.