Kenwood TH-K2AT Instruction Manual

Also see for TH-K2AT: Service manual Instruction manual Service manual

Contents

68S CAN RESUME M ETHODThe transceiver stops scanning at the frequency (ormemory channel) where a signal is detected. It thencontinues or stops scanning according to which ResumeMode you have selected.• Time-Operated Mode (default)The transceiver remains on a busy frequency (ormemory channel) for approximately 5 seconds, thencontinues to scan even if the signal is still present.• Carrier-Operated ModeThe transceiver remains on a busy frequency (ormemory channel) until the signal drops out. There isa 2-second delay between signal dropout and scanresumption.• Seek ModeThe transceiver moves to a frequency or memorychannel where a signal is present and stops.To change the scan resume method:1 Press [MENU].2 Turn the Tuning control to select Menu No. 11 (SCAN).3 Press [MENU].4 Turn the Tuning control to select “TO” (Time-Operated),“CO” (Carrier-Operated), or “SE” (Seek) Mode.5 Press [MENU] to store the new setting. Otherwise,press [PTT] to cancel.