TK-3170/31732INTRODUCTIONSCOPE OF THIS MANUALThis manual is intended for use by experienced techni-cians familiar with similar types of commercial grade commu-nications equipment. It contains all required service informa-tion for the equipment and is current as of the publicationdate. Changes which may occur after publication are coveredby either Service Bulletins or Manual Revisions. These areissued as required.ORDERING REPLACEMENT PARTSWhen ordering replacement parts or equipment informa-tion, the full part identification number should be included.This applies to all parts : components, kits, or chassis. If thepart number is not known, include the chassis or kit numberof which it is a part, and a sufficient description of the re-quired component for proper identification.PERSONAL SAFETYThe following precautions are recommended for person-nel safety:• DO NOT transmit until all RF connectors are verified se-cure and any open connectors are properly terminated.• SHUT OFF and DO NOT operate this equipment near elec-trical blasting caps or in an explosive atmosphere.• This equipment should be serviced by a qualified techni-cian only.SERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained within.GENERAL / SYSTEM SET-UPSYSTEM SET-UPMerchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingAre you using the optional antenna?Are you using the speaker microphone?A personal computer (IBM PC or compatible), programminginterface (KPG-22), and programming software (KPG-101D)are required for programming.(The frequency, TX power HI/LOW, and signaling data areprogrammed for the transceiver.)Frequency range (MHz) RF power TypeTX/RX 450~490 4W TK-3170 K,K4TK-3173 KYES KRA-23 or KRA-27Optional antennaNONO(Option)(Option)YES KMC-17 or KMC-21Speaker microphoneDelivery