Kenwood TK-3360 Instruction Manual

Also see for TK-2360: Instruction manual Service manual Instruction manual Instruction manual

Contents

4INSTALLING THE BELT CLIPNote: When first installing the belt clip, you must remove thebattery pack from the rear of the transceiver.1 Remove the 2 screws from therear of the transceiver, thenremove the small, plastic blackcovering that was held in place.2 Insert the belt clip mount intothe space on the rear of thetransceiver.3 Using the 2 screws, affix the beltclip in place.• When the belt clip is not installed, leave the plastic covering inplace.• Do not use glue which is designed to prevent screw looseningwhen installing the belt clip, as it may cause damage to thetransceiver. Acrylic ester, which is contained in these glues, maycrack the transceiver’s back panel.INSTALLING THE CAP OVER THE SPEAKER/ MICROPHONE JACKSInstall the cap over the speaker/ microphone jacks when notusing an optional speaker/ microphone.Note: To keep the transceiver water resistant, you must cover thespeaker/ microphone jacks with the supplied cap.1 Place the cap over the jacks so that thelocking tabs insert into the transceivergrooves.Plasticcovering