Kenwood TK-5910 Instruction Manual

Also see for FleetSync TK-5810(H): Specifications Service manual Service manual Instruction manual

Contents

5SCANScan is useful for monitoring signals on the transceiver channels. Whilescanning, the transceiver checks for a signal on each channel and only stops on achannel if a signal is present.To begin scanning, press the key programmed as Scan.• The (KCH-4) or SCAN (KCH-5) icon appears on the display.• The channel add indicator (KCH-4: / KCH-5: ) willappear on the display when the selected channel is added to the scan sequence.• The channels included in the scan list are scanned.• When a signal is detected on a channel, Scan pauses on that channel. The transceiverwill remain on the busy channel until the signal is no longer present. When the signal“drops out”, the transceiver will remain on the channel momentarily before Scanresumes. This delay time is programmed by your dealer. If a signal is received duringthe delay time, the transceiver will remain on the same channel.To stop scanning, press the Scan key again.Note:◆ If the currently selected channel is not added to the scanning sequence, Scan will not functionwhen pressing the key programmed as Scan. Be sure that the selected channel is added tothe scanning sequence before operating Scan.◆ In order for Scan to function, there must be at least channels added to the scanningsequence. If there are less channels than this, Scan will not operate.TemporAry chAnnel locKouTIf a key is programmed with the Scan Delete function, each channel can belocked out of the scan sequence manually.During scan, you can temporarily remove specific channels from the scanningsequence by selecting them and pressing the Scan Delete key.• The channel add indicator (KCH-4: / KCH-5: ) nolonger appears on the display for that channel.• The channel is no longer scanned. However, when scanning is ended and restarted, thechannels will reset and the channel will again be in the scanning sequence.