TK-61102Document CopyrightsCopyright 2011 by Kenwood Corporation. All rights re-served.No part of this manual may be reproduced, translated,distributed, or transmitted in any form or by any means, elec-tronic, mechanical, photocopying, recording, or otherwise,for any purpose without the prior written permission of Ken-wood.DisclaimerWhile every precaution has been taken in the prepara-tion of this manual, Kenwood assumes no responsibilityfor errors or omissions. Neither is any liability assumed fordamages resulting from the use of the information containedherein. Kenwood reserves the right to make changes to anyproducts herein at any time for improvement purposes.DISASSEMBLY FOR REPAIRCompatibility informationThe Final transistor (Q5,6:2SC2540) has been discontinued by the supplier, so New Final transistor (2SC2782A) has beenapplied on to X57-6100-XX production.CompatibilityOLD Part NEW Part(TX-RX Unit : X57-6100-XX)TK-6110 K,K2Ref.Q5,Q6Part NameNoNoS/No. A8B00001 onwardsS/No. 91200110 and beforePC board(X57-6100-XX)Final transistor 2SC2540J72-0720-x22SC2782AJ79-0225-x9Merchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingAre you using the external speaker?Are you using the ignition sense cable?DeliveryNONOKES-4 (EXT. SP)YESKCT-18YESA personal computer programming interface (KPG-46),and programming software (KPG-59D) are required for programming.(The frequency and signalling data are programmed for the transceiver.)Frequency range29.7~37MHz35~50MHzRF power70W70WTK-6110 KTK-6110 K2TypeSYSTEM SET-UP“ Note :Internal beat interference exists at both 33.600MHz and 42.000MHz.”