Kenwood TK-630 series Instruction Manual

Also see for TK-630 series: Instruction manual

4-4. SCAN OPERATION4-4-1. GeneralThere are two “mic hook” scan modes in which the radio can be programmedto operate.@ On Hook Scan:Normal method of scanning that requires the microphone to be on hook (inthe mic hanger) to initiate scan, and for channel scanning to occur.The microphone does not have to be on hook to initiate scan or to scanchannels. Off hook scan should be used on radios implementing amicrophone headset or handset that use a combined PTT/hook switch.Off Hook Scan:(1) The scan feature is enabled by pressing the front panel SCN switch.(2) A single confirmation tone sounds, and scanning starts. If there is one or(3) The display shows SCAN (or SC) and the SCAN (SCN) indicator lights.(4) If the transceiver receives a signal while scanning, the scanning stopsless added channels, an error tone sounds, and scanning does not start.temporarily, the audio is unmuted, and the channel is displayed.1. If the channel is not the priority channel and there is a priority channel,the radio receives the signal alternately between the channel and thepriority channel.2. If the channel is the priority 2 channel and there is a priority 1 channel,the radio receives the signal alternately between the priority 2 and thepriority 1.3. If there is no priority channel, the scanning stops at that channel andreceives only that channel.(5) If the SCN switch is pressed again, an operation confirmation tone sounds,and the scanning ends (scan mode is exited). (The channel selectedimmediately before the scanning began returns.)4-4-2. To transmit while scanning.On Hook Scan(1) Take the microphone off hook. The radio goes to the off-hook revertchannel.(2) When the PTT switch is pressed, transmission takes place on the displayedrevert channel.Off Hook ScanUpon pressing PTT, the radio ceases scanning and goes to the off-hookrevert channel on which transmission begins immediately.4-4-3. To delete nuisance channels while scan is on.( 1 ) To temporarily delete undesirable channels, press the D/A switch 2 secondswhile the channel is active (indicated by the display).A confirmation tone sounds, the currently displayed channel is deleted, andthe scanning resumes. The last channel in the scan sequence cannot bedeleted. (The priority channel can only be deleted if the “priority temporarilydelete” feature is enabled in the “scan information” programming.)(2)To restore the original scan list, either turn scan off and on or turn the radiooft amd on.1 2