Kenwood TK-7150 Service Manual

Also see for TK-7150: Specifications Specifications Instruction manual Instruction manual

Contents

TK-715035-2. Radio locationSelect a convenient location for your control station radiowhich is as close as practical to the antenna cable entry point.Secondly, use your system’s power supply (which suppliesthe voltage and current required for your system). Make suresufficient air can flow around the radio and power supply toallow adequate cooling.Merchandise receivedLicense and frequencyallocated by FCCChoose the type of transceiverFrequency range RF power Type136~174MHz 50W TK-7150 KAre you usingthe remote kit?YES KRK-9Control cable KCT-22M : 8 feetM2 : 17 feetM3 : 25 feetAre you usingthe key label? Supplied key labelAre you usingthe voice scrambler/ANI?Modified of control unitAre you usingthe ignition sensecable?KCT-18Are you usingthe noise-canceling micro-phone?KMC-28ASupplied microphoneDeliveryTransceiver programmingDC power cableSupplied cable orKCT-23 M : 10 feetKCT-23 M3 : 23 feetAre you usingthe external speaker?Are you usingthe keypad microphone?YESYESYESExternal speaker KES-5YESYESKMC-27AYESNONONONONONONOSee page 5.A personal computer (IBM PC or compatible), programming interface (KPG-46),and programming software (KPG-79D) are required for programming.See page 8.See page 7.See page 9.See page 7.See page 7.DC power supply KPS-10ADesk top microphone KMC-9CSERVICEThis radio is designed for easy servicing. Refer to theschematic diagrams, printed circuit board views, and align-ment procedures contained in this manual.GENERAL / SYSTEM SET-UPSYSTEM SET-UP