Kenwood TK-7302H Instruction Manual

Also see for TK-7302: Instruction manual Instruction manual Service manual Instruction manual Instruction manual

6SCANScan monitors for signals on the transceiver channels. While scanning, thetransceiver checks for a signal on each channel and only stops if a matchingsignal is present.To start/stop scanning, press the key programmed as Scan On/Off.• “Sc” appears on the display during Scan.• When a signal is detected, Scan pauses at that channel. The transceiver will remain onthe busy channel until the signal is no longer present, at which time Scan resumes.Note: To use Scan, there must be at least 2 channels added to the scanning sequence.priority ScAnIf a Priority channel has been programmed, the transceiver will automaticallychange to the Priority channel when a call is received on that channel, even if callis being received on a normal channel.• “P” appears on the display to indicate the Priority channel (depending on dealer setting).temporAry chAnnel lockoutDuring scan, you can temporarily remove specific channels from the scanningsequence by pressing the key programmed as Scan Delete/Add while Scan ispaused at the undesired channel. To temporarily remove a zone, press and holdScan Delete/Add while Scan is paused at a channel in the undesired zone.• The channel/zone is no longer scanned. However, when scanning is ended andrestarted, the Scan settings return to normal.ScAn delete/AddYou can add and remove zones and/or channels to and from your scan list.1 Select your desired zone and/or channel.2 Press the key programmed as Scan Delete/Add to remove a channel or pressand hold the key for approximately second to remove a zone.• When a channel is added to scan, “cA” appears on the display. When it is removed,“cd” appears on the display.• When a zone is added to scan, “GA” appears on the display. When it is removed,“Gd” appears on the display.