Kenwood TK-8150 Service Manual

Also see for TK-8150: Specifications Specifications Instruction manual Instruction manual Service manual

Contents

TK-815071. Installing Name PlatePunch out the name plate card. Then insert the platesonto the relative function keys.You can reconfigure the name plates at any time.3. External Speaker (KES-5)The external speaker output from the accessory connector(6 pin) on the rear of the transceiver is 13W/4Ω. Use the KES-5.3-1. Connection for the KES-5 with the TK-8150■ When taking the AF output from the accessoryconnector (6-pin) on the rear of the radioThe following tools are required for changing the connector.• Extracting toolThe following extracting tool is recommended;Molex inc. Order No. : J5800-002 (W05-0878-00)1. Remove the connector with jumper from the externalspeaker connector on the rear panel of the radio (Fig. 3-1).Note : Save the jumper, which is required when the radiois used without the external speaker.2. Remove the terminals with the jumper from the connec-tor housing holes number 5 and 6 using the extractingtool.Removing the jumper lead (Fig. 3-2)1) Insert the extracting tool (J5800-002) into the connec-tor while pushing the jumper lead in the direction of (a).2) Push the extracting tool into collapse the barbs of thecrimp terminal.3) Pull out the lead while continuing to push the extractingtool in the direction (b).3. Cut off the end of the protection cover, insert the KES-5speaker cable into the protective cover.4. Reinsert the terminal with the black and white stripe leadinto hole number 5, and the terminal with the black leadinto hole number 4 (Fig. 3-3).5. Install the plug and protective cover on the accessory con-nector on the rear of the transceiver, then clamp the bot-tom of the protective cover with the supplied tie wrap.INSTALLATIONName plates forthe function keysPunch out thename plate cardsSqueeze andinsert the platesName platesSide view of the keyFig. 12. Ignition Sense Cable (KCT-18)The KCT-18 is an optional cable to use the following func-tions;2-1. Ignition FunctionThe ignition function allows you to turn the transceiver’spower on and off with the ignition key of your car. When youare driving with the ignition key on, the horn alert function isdisabled.2-2. Timed Power Off FunctionThe timed power off function turns the transceiver’spower off the time specified with the programming software(KPG-79D) after the ignition key is turned off. When you aredriving with the ignition key on, the horn alert function is dis-abled.The ignition sense function and the timed power off func-tion can be used at the same time.2-3. Modification1. Remove the short plug from the accessory connector (6pins) on the rear of the transceiver.2. Cut off the end of the protective cover (accessory), insertthe KCT-18 into the protective cover, and insert it into pin1 (IGN) of the short plug.3. Install the short plug and protective cover on the connec-tor on the rear of the transceiver, then clamp the bottomof the protective cover with the supplied tie wrap.Fig. 2CutTie wrapProtective coverKCT-1813 46Short plugSquare-type plug(E37-1031-05)(a)(b)JumperleadExtracting tool(J5800-002)Crimp terminalCrimp terminal(E23-0613-05)BarbsCutTie wrapProtective cover45Short plugBlack leadBlack/White leadSpeaker cable (to KES-5)Fig. 3-1Fig. 3-2Fig. 3-3