Kenwood TK-8302 Service Manual

Also see for TK-8302: Instruction manual Instruction manual Instruction manual Instruction manual Instruction manual

Contents

TK-8302/8302H4Merchandise receivedLicense and frequency allocated by FCCChoose the type of transceiverTransceiver programmingKCT-60Connection cableKCT-36Extension cableKES-5External speakerKCT-18Ignition sense cableKES-3External speakerSee page 4.A personal computer, programming interface (KPG-46/46A),and FPU (programming software) are required for programming.Frequencyrange (MHz) RF power Type400~470 25W TK-8302 M2TK-8302H K2400~470 45W(Option)(Option)(Option) (Option)(Option)DeliverySee page 7. See page 7. See page 7.See page 6.SYSTEM SET-UP1. ModesUser modePC mode PC programming modePC test mode PC tuning modeClone modeMode FunctionUser mode For normal use.PC mode Used for communication between the trans-ceiver and PC.PC programmingmodeUsed to read and write frequency data andother features to and from the transceiver.PC test mode Used to check the transceiver using the PC.This feature is included in the FPU.PC tuning mode Used to tune the transceiver using the PC.Clone mode Used to transfer programming data from onetransceiver to another.REALIGNMENT2. How to Enter Each ModeMode OperationUser mode Power ONPC mode Received commands from PCClone mode [ ]+Power ON (Two seconds)3. PC Mode3-1. PrefaceThe transceiver is programmed using a personal com-puter, a programming interface (KPG-46/46A, USB adapter(KCT-53U)) and FPU (programming software).The programming software can be used with a PC. Fig-ure 1 shows the setup of a PC for programming.3-2. Connection procedure1. Connect the transceiver to the computer using the inter-face cable and USB adapter (When the interface cable isKPG-46A, the KCT-53U can be used.).