Kenwood TK-D740HV User Manual

Also see for TK-D740: User guide User guide User guide User manual

18SCANScan monitors for signals on the transceiver channels. While scanning, thetransceiver checks for a signal on each channel and only stops if a matchingsignal is present.To start/ stop scanning, press the key programmed as [Scan].• “Sc” appears on the display during Scan.• When a signal is detected, Scan pauses at that channel. The transceiver willremain on the busy channel until the signal is no longer present, at which timeScan resumes.Note:◆ To use Scan, there must be at least 2 channels added to the scanning sequence.PRIORITY SCANIf a Priority channel has been programmed, the transceiver will automaticallychange to the Priority channel when a call is received on that channel, even if callis being received on a normal channel.• “P1” appears on the display to indicate the Priority channel 1.• “P2” appears on the display to indicate the Priority channel 2.• “PP” appears on the display to indicate the Priority channels 1 and 2.TEMPORARY CHANNEL LOCKOUTDuring scan, you can temporarily remove specific channels from the scanningsequence by pressing the key programmed as [Scan Delete/Add] while Scan ispaused at the undesired channel.• The channel is no longer scanned. However, when scanning is ended andrestarted, the Scan settings return to normal.SCAN DELETE/ ADDYou can add and remove zones and/or channels to and from your scan list.1 Select your desired zone and/or channel.2 Press the key programmed as [Zone Delete/Add] (to add/remove zones) or[Scan Delete/Add] (to add/remove channels).• When a zone is added to scan, “GA” appears on the display. When it isremoved, “Gd” appears on the display.• When a channel is added to scan, “cA” appears on the display. When it isremoved, “cd” appears on the display.