Kenwood TKR-850 Service Manual

Also see for TKR-850: Brochure & specs Function reference Instruction manual Instruction manual Programming reference

TKR-85085. Key CoverTo avoid accidentally pressing the keys, you can install thekey cover.1. Install and fix the key protector using the 5 suppliedscrews (N35-3006-45).Screws(N35-3006-45) x 56. Desktop RepeaterWhen you use the repeater on the desktop, attach the 4spacers to the base of the repeater as shown in figure. Withthese spacers attached, the front panel will not touch thedesk surface.PegsFirmly press these pegs(J59-0302-05) through thespacers to affix them tothe repeater. Peel off the backing paperto attach these spacers(J02-0492-04).Spacers(J02-0475-05)7. Installing Name PlatesPunch out the name plate card. Then insert the platesonto the reltative function keys.You can reconfigure the name plates at any time.Side view of the keySqueeze andinsert the plates.Name plates forthe function keysName platesPunch out thename plate cardsMODIFICATION1. DC Source SwitchTo prevent the power supply from turning off due tomisoperation of the DC source switch on the front panel oraccidents (tampering) after installation, the main unit can bekept on regardless of the on/off of the DC source switch onthe front panel.Short the PSW land near K1 relay by soldering.TX-RX unit (A/2)Component sideK1CF1WIDECF2NARROWPSWINSTALLATION / MODIFICATIONFig. 6Fig. 7Fig. 8Fig. 1