Kenwood TM-D710 Setup Manual

Also see for TM?D710: Instruction manual Overview guide Quick guide

Kenwood TM-D710 Setup Manual Manual pdf 1 page image

K5MWRev. 2 Page 1 6/2/2008Basic APRS Setup for the Kenwood TM-D710Using the Avmap G5 or G4TThese instructions provide the information necessary to configure your Avmap G5 orG4T GPS and your Kenwood TM-D710 VHF/UHF transceiver for basic APRSoperation. After you have achieved basic operation and have some experience with thesystem, you may want to adjust various parameters to more closely meet your particularenvironment and operating requirements.These instructions assume that both units are at factory default settings. If you haveproblems getting the system to work, return both units to factory default. Perform theseinstructions, and then reset any other settings to your preference.Interconnecting the EquipmentIn North America, the Avmap G5 and G4T are sold with a cable that is pre-wired for usewith designated Kenwood radios, including the TH-D7x, the TM-D700x, and the TM-D710x (x is usually either A or E). The input/output port used for APRS on the Avmap isthe same port that is used for TMC, and is labeled TMC on the back of the Avmap. Dueto the multi-use of the TMC port, it is not possible to operate APRS and TMCsimultaneously.With both your radio and G5 turned OFF, plug the 3-pole connector (one metal ring) endof the APRS cable that came with your GPS into the GPS port on left side of the D710control head. Insert the 4-pole connector (2 metal rings) into the TMC port on the back ofyour G5 unit. Make sure that you don’t get the connectors reversed, and that you areplugged into the TMC port, not the antenna port. Also be sure that the connectors arefully seated.Geosat 5 Setup• Turn your G5 ON and press the MENU key• Select "Settings" at the bottom of the menu• Select "User Preferences"• Touch the blue NEXT arrow to proceed to USER PREFERENCES 2/2• Touch the INTERFACE button to go to the INTERFACE page• On the INTERFACE page, select either APRS4800 or APRS9600 as appropriateto your radio interface. (APRS9600 is recommended if your radio will support it)• Select "OK" at the bottom right of the page• Again, select “Settings” at the bottom of the “Menu” page• Select “Map Icons”• Touch the blue NEXT arrow to proceed to MAP ICONS Contacts - 3/3• Select the Contacts menu option (probably the only one available)• Select “OK”• Return to the map page