Kenwood VZ-7000N Instruction Manual

Also see for VZ-7000N: Installation manual

Name SetIf the cursor is in the desired character inputposition, go on to step 4. If not, touch either [ 2 ] or[ 3 ] to move the cursor to the desired position.Touching [ 2 ] moves the cursor to the left andtouching [ 3 ] moves it to the right.Touch [ ∞ ] or [ 5 ] to switch the character lists.When all characters are displayed on the characterlist, [ ∞ ] and [ 5 ] do not appear.Touch [ A B ], [ a b ], [ 1 2 ] or [ Ä ä ] to switch thecharacter lists.Touch a character.Continue steps 1 and 4 until all the characters havebeen input for the name.• You can enter up to 12 characters for each name.• To enter a space, touch [ SPC ].Touch [ OK ] to finish name entry and leave thename preset mode.• If you want to change the name of a station, firstdisplay the name of the station (following step 1),then change the letter(s) that you by following steps1, and 4.• You can assign names to up to 30 TV stations.• Names registered on this unit will not be displayedon the Center unit.NOTE6NOTE543NOTE21English15AN A M E # P R E S E T #B C D E FG H I J K LM N O P Q RS T U V W XY Z , . • -O KN A M E S E TS P CA Ba b1 2Ä äName Set Screen