29XD SERIES (En)KnowledgeRemedyCauseSymptom÷ Clean the head referring to “Maintenance”.÷ Try another tape.÷ Play a recorded tape.÷ Close the holder completely.÷ Insert a tape.÷ Try another tape.÷ Reverse the tape insertion orientation.÷ Clean the head referring to “Maintenance”.÷ Try another tape.÷ Demagnetize the head referring to “Main-tenance”.÷ Install the system at a distance from otherelectric appliances and TV.÷ This unit can not play tapes recorded withDolby NR ON with the correct sound quality÷ Clean the head referring to “Maintenance”.÷ Wind the tape again by fast forwarding,rewinding or playing from an end to theother.÷ Use a cassette with an unbroken recordingprotect tab or block the hole.÷ Close the holder completely.÷ Reverse the tape insertion orientation.Sound cannot be produced by pressingthe play key or no operation occurs evenwhen an operation key is pressed.No operation occurs even when an opera-tion key is pressed.Sound is harsh or high frequencies are notreproduced.Noise is noticeable.Sound vibrates.Recording cannot be started by pressingthe record key.÷ The head is dirty.÷ The tape is wound too tight due to irregularwinding.÷ A nonrecorded tape is played.÷ The cassette holder is not closed com-pletely.÷ A tape is not inserted in the unit.÷ The tape is wound too tight due to irregularwinding.÷ The tape is fully wound to one of the reels.÷ The head is dirty.÷ The tape is stretched or shrunk.÷ The tape head is magnetized.÷ External noise is induced.÷ A tape recorded with Dolby NR ON is beingplayed on this unit.÷ The capstans or pinch rollers are dirty.÷ The tape is wound irregularly.÷ The recording protect tab of the cassettehas been broken.÷ The cassette holder is not closed com-pletely.÷ The tape is fully wound to one of the reels.Cassette deck1. With some tapes, a squeaky noise is produced when the tape is stopped automatically. This is due to the tape protection function,and not a malfunction.2. Do not use longer tape than 110 minutes tapes, for the tape is too thin and gets easily tangled.NotesNotesIn case of difficultyRemote control unitSymptom Cause RemedyRemote control operation is not possible. ÷ Batteries are exhausted.÷ The remote control is too far away from thesystem, the controlling angle is deviated orthere is an obstacle in between.÷ There is no tape or CD set in the componentto be played.÷ Replace with new batteries.÷ Operate the unit inside the remote control-lable range.÷ Set a tape or CD in the component to beplayed.@@^¶™™™¶¶¶™7™™