Kenwood XD-753 Instruction Manual

Contents

Kenwood XD-753 Instruction Manual Manual pdf 2 page image

2Preparation sectionBefore applying power Caution : Read this page carefully to ensure safe operation.For the United KingdomFactory fitted moulded mains plug1.The mains plug contains a fuse. For replacement, use onlya 13-Amp ASTA-approved (BS1362) fuse.2.The fuse cover must be refitted when replacing the fuse inthe moulded plug.3.Do not cut off the mains plug from this equipment. If theplug fitted is not suitable for the power points in your homeor the cable is too short to reach a power point, then obtainan appropriate safety approved extension lead or adapter,or consult your dealer.If nonetheless the mains plug is cut off, remove the fuseand dispose of the plug immediately, to avoid a possibleshock hazard by inadvertent connection to the mainssupply.IMPORTANT: The wires in the mains lead are colored inaccordance with the following code:Blue : NeutralBrown : LiveDo not connect those leads to the earth terminal of a three-pin plug.Safety precautionsWARNING : TO PREVENT FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THISAPPLIANCE TO RAIN OR MOISTURE.CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOTREMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTSINSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.RISK OF ELECTRIC SHOCKDO NOT OPENTHE LIGHTNING FLASH WITH ARROWHEAD SYMBOL, WITHIN AN EQUILATERAL TRIANGLE, IS IN-TENDED TO ALERT THE USER TO THE PRESENCE OF UNINSULATED “DANGEROUS VOLTAGE” WITHINTHE PRODUCT’S ENCLOSURE THAT MAY BE OF SUFFICIENT MAGNITUDE TO CONSTITUTE A RISKOF ELECTRIC SHOCK TO PERSONS.THE EXCLAMATION POINT WITHIN AN EQUILATERAL TRIANGLE IS INTENDED TO ALERT THE USERTO THE PRESENCE OF IMPORTANT OPERATING AND MAINTENANCE (SERVICING) INSTRUCTIONSIN THE LITERATURE ACCOMPANYING THE APPLIANCE.CAUTION*AC voltage selectionThe AC voltage selector switch on the rear panel is set tothe voltage that prevails in the area to which the unit isshipped. Before connecting the power cord to your ACoutlet, make sure that the setting position of this switchmatches your line voltage. If not, it must be set to yourvoltage in accordance with the following direction.AC voltage selector switchMove switch lever to match your line voltage with asmall screwdriver or other pointed tool.Note:Our warranty does not cover damage caused by exces-sive line voltage due to improper setting of the ACvoltage selector switch.Inside this laser product, a laser diode classified as Class3A laser radiation is contained as alerted by the internalcaution label shown above. To avoid exposure to laserbeams, do not open the cover.The marking of products using lasers(Except for some areas)Units are designed for operation as follows.Europe and U.K. ................................................. AC 230 V onlyChina.................................................................... AC 220 V only*Other countries ........... AC 110-120 / 220-240 V switchableU.S.A. and Canada ............................................ AC 120 V onlyAustralia ............................................................. AC 240 V onlyAC 220-240V~AC 110-120V~AC 220-240V~AC 110-120V~CAUTIONINVISIBLE LASER RADIATIONWHEN OPEN. AVOID EXPO-SURE TO BEAM.The marking is located on the rear panel and says thatthe component uses laser beams that have been clas-sified as Class 1. It means that the unit is utilizing laserbeams that are of a weaker class. There is no danger ofhazardous radiation outside the unit.CLASS 1LASER PRODUCTThe marking of products using lasers(Except for some areas)