XD SERIES (En/E2)7 Preparation section Basic section Application section Knowledge sections− +44÷ When connecting the parallel cord, insert plug straight into theconnector until it clicks to look them securely.÷ When connecting the parallel cord, the wire while line should cometo the left side end.÷ When disconnecting the parallel cord, push in the two sides of theplug and pull it straight out.1. Be sure to insert all connectioncords securely. If their connec-tions are imperfect, the soundmay not be produced or noisemay interfere.2. Before plugging or unplugginga connection cord, be sure tounplug the power cord fromthe wall AC outlet. If connec-tion cords are plugged or un-plugged with the power cordleft plugged in, malfunction ordamage may result.3. When arranging the systemunits in a vertical, stacked con-figuration, observe the stack-ing order indicated in the sys-tem connection diagram.4. In case an associated systemcomponent is connected, alsoread the instruction manual ofthe component.5. Align the front panels of all setsflush.6. Never short-circuit the + and –speaker cords.7. If the left and right speaker con-nections or the + and – polarityare inverted, the sound will beunnatural with unclear position-ing of musical instruments, etc.Be sure to connect them with-out mistake.NotesNotesTwistSpeaker UnitTo maintain proper ventilation,be sure to leave a space aroundthe unit (from the largest outerdimensions including projec-tions) equal to, or greater than,shown below.top panel: 50 cmrear panel: 10 cmleft and right panels: 10 cmSystem connectionSpeaker (left)321 4Please install as shown below, as oth-erwise fire may be caused by overheat-ing.Caution regarding placement(Front View)The external view is variable dependingon the model and marketing destinationtype.Main unitTwist321 4Connection of parallel cordFrom the top to the bottomAmplifier :A-H5Tuner/Equalizer :C-H6 or C-H5CD player :DP-H5 or DP-MH5Cassette deck :X-H5