Kenwood eXcelon KAC-X10D Instruction Manual

Also see for KAC-X10D - eXcelon Amplifier: Training guide Instruction manual Service manual

Contents

6 EnglishControls1 Fuse (40 A × 1)NOTEIf you can’t find the specified capacity fuse at your store etc., consult yourKenwood dealer.2 Battery terminal3 Ground terminal4 Power control terminalControls the unit ON/OFF.NOTEControls the unit power. Be sure to connect it with all the systems.5 Speaker output terminalsAs this unit accepts speakers with a minimum impedance of 1 ohm, connectspeakers with 1-ohm or higher impedance to these terminals.2CAUTIONThe rated input of the speakers should be no less than the maximum outputof the amplifier. Otherwise malfunction may result.6 ISF (infrasonic filter) switchUltralow frequencies that cannot be reproduced even by a subwooferspeaker do not become sound but become unnecessary oscillations, whichaffect the sound by causing distortion, etc. Setting this switch to "15 Hz" or"25 Hz" cuts the frequencies below the respective frequency.This improves the reproduction performance of the speakers by eliminatingunnecessary oscillations which will not become sound.7 LPF(Low-Pass Filter) FREQUENCY controlThis control adjusts the frequency band output from this unit.8 LINE OUT FILTER switchChanging over the audio signal output to the LINE OUT terminal.ON position:The audio signal adjusted when setting LPF, INPUT SENSIVITY control andBass boost (optional accessory) is output to the LINE OUT terminal.OFF position:The audio signal input from the LINE IN terminal is output to the LINE OUTterminal (through output).2CAUTIONThe volume of the audio output to the LINE OUT terminal is different in ONand OFF position. Remember this when changing the LINE OUT FILTER switchfrom ON to OFF.9 INPUT SENSITIVITY controlSet this control according to the pre-output level of the center unitconnected with this unit.NOTEFor the pre-output level, refer to the in the instructionmanual of the center unit.0 REMOTE terminalConnects the Remote cable.NOTEUse the Remote cable of the accessory.! LINE IN terminal@ LINE OUT terminalThe audio signal set with the LINE OUT FILTER switch will be output.# Power idndicatorWhen the power is turned on, the Power indicator lights.If the Power indicator does not light when the power is turned on, theprotection function may be activated. Check whether there is any indicationof trouble. (See page 2)$ BOOST LEVEL (Bass boost level) controlSets the level by which the low frequency range should be boosted.% Power idndicator^ FREQUENCY (Bass boost frequency) controlSets the center frequency around which the low frequency range should beboosted.40} p q r s t u v w x y z {|~Remote controller(Optional accessory)