Kenwood eXcelon KAC-X20 Instruction Manual

Also see for KAC X20 - eXcelon Amplifier: Training guide Service manual

Contents

English 3380 mm320 mmØ6272 mm286 mmInstallation board, etc.(thickness : 15 mm or more)Self-tapping screw(ø5 × 18 mm)Cooling fanInstallationAccessoriesPart name External View Number of ItemsSelf-tapping screws(ø5 × 18 mm) 4Terminal cover (Power terminal) 1Hexagon Wrench 1Installation procedureSince there are large variety of settings and connections possible according toapplications, read the instruction manual well to select the proper setting andconnection.1. Remove the ignition key and disconnect the negative - terminal of thebattery to prevent short circuits.2. Set the unit according to the intended usage.3. Connect the input and output wires of the units.4. Connect the speaker wires.5. Connect the power wire, power control wire and grounding wire following thisorder.6. Install the installation fittings in the unit.7. Attach the unit.8. Install the remote controller. (Optional accessory)9. Connect the negative - terminal of the battery.2CAUTION• Do not install in the below locations;(Unstable location, In a location that interferes with driving, In a locationthat gets wet, In a dusty location, In a place that gets hot, In a place thatgets direct sunlight, In a location that gets hit by hot air)• Do not install the unit under the carpet. Otherwise heat build-up occursand the unit may be damaged.• Install this unit in a location which allows heat to easily dissipate.Once installed, do not place any object on top of the unit.• The surface temperature of the amplifier will become hot during use. Installthe amplifier in a place where people, resins, and other substances that aresensitive to heat will not come into contact with it.• This unit has cooling fan to decrease the internal temperature. Do notmount the unit in a place where the cooling fan and ducts of the unit areblocked. Blocking these openings will inhibit the cooling of the internaltemperature and result in malfunction.• When making a hole under a seat, inside the trunk, or somewhere else inthe vehicle, check that there is nothing hazardous on the opposite sidesuch as a gasoline tank, brake pipe, or wiring harness, and be careful not tocause scratches or other damage.• Do not install near the dashboard, rear tray, or air bag safety parts.• The installation to the vehicle should securely fasten the unit to a place inwhich it will not obstruct driving. If the unit comes off due to a shock andhits a person or safety part, it may cause injury or an accident.• After installing the unit, check to make sure that electrical equipmentsuch as the brake lamps, turn signal lamps and windshield wipers operatenormally.Hexagon sockethead cap screw(M4 × 8 mm)Hexagon WrenchDressing coverRemote controllerSelf-tapping screw(ø2.6 × 12 mm)Mounting bracket■ Remote controller (Optional accessory) AccessoriesPart name External View Number of ItemsRemote cable (6.0 m : 19.7 ft) 1Remote controller 1Mounting bracket 1Self-tapping screws(ø2.6 × 12 mm) 2