Kenwood nx-720h Instruction Manual

Also see for Nexedge NX-720H: Instruction manual Service manual Instruction manual

Contents

8SCANScan monitors for signals on the transceiver channels. While scanning, the transceiverchecks for a signal on each channel and only stops if a signal is present.To begin scanning, press the key programmed as [Scan].• The indicator appears.• When a signal is detected on a channel, Scan pauses at that channel. The transceiverwill remain on the busy channel until the signal is no longer present, at which time Scanresumes.To stop scanning, press the [Scan] key again.Note: To use Scan, there must be at least 2 channels in the scan sequence.TEMPORARY CHANNEL LOCKOUTDuring scan, you can temporarily remove specifi c channels from the scanning sequence byselecting them and pressing the key programmed as [Scan Delete/Add].• The channel is no longer scanned. However, when scanning is ended and restarted,the channels are reset and deleted channels will again be in the scanning sequence.PRIORITY SCANIf a Priority channel has been programmed, the transceiver will automatically change to thePriority channel when a call is received on that channel, even if a call is being received ona normal channel.• The indicator appears when the selected channel is the Priority channel (dependingon dealer setting).SCAN REVERTThe Scan Revert channel is the channel selected when you press the PTT switch totransmit during scan. Your dealer can program one of the following types of Scan Revertchannels:• Selected: The last channel selected before scan.• Selected + Talkback: Same as “Selected”, plus you can respond to calls on thechannel at which scan is paused.• Priority: The Priority channel.• Priority + Talkback: Same as “Priority”, plus you can respond to calls on the channelat which scan is paused.• Last Called + Selected: The last channel on which you receive a call.