Solar Controller SRK868V6 Installation and Operation Instructionshttp://www.keracontrols.com 51. Safety information• When laying cables, please ensure that no damage occurs to any of the safety installations in the building.• The controller must not be installed in rooms with flammable gasses or materials.• Make sure that the environmental conditions do not exceed the controller and other systems specifications.• Before connecting the device, make sure that the Power Supply Line specifications match the controller.• All devices connected to the controller must conform to the technical specifications of the controller.• All installation must be performed ONLY when ALL POWER is disconnected. All local work and safety regulations mustbe followed. Wiring or any operations that require opening of electrical enclosures (e.g. even changing the fuse) shouldbe performed by qualified personnel.• Installation, electrical wiring, setup and maintenance of the device should be performed by trained, professionalpersonnel familiar with this manual and should follow the instructions contained herein.The manufacturer cannot monitor the compliance with these instructions or the circumstances and methods used duringinstallation, operation and maintenance of this controller. Improper installation can cause damage to people and equipment.Therefore, the manufacturer and the retailer are not liable for any losses, damages or cost that might arise due to improperinstallation, operation or use and maintenance of the system.If it becomes evident that safe operation is no longer possible (for instance visible damage), please make sure that thesystem is powered OFF and deactivated immediately.Note: Ensure that the device cannot be accidentally put into operation.The manufacturer reserves the right to make changes to the product, technical specifications or installation and operationinstructions without prior notice.