Keysight Technologies N7373C Programmer's Manual

Also see for N437 Series: Application note

Keysight Technologies N7373C Programmer's Manual Manual pdf 46 page image

The LCA SCPI interface is implemented on the LCA RemoteInterface methods and the Agilent Translator Framework.Therefore the LCA Server starts automatically when you startthe LCA SCPI interface. When you click on the “Start SCPI”button on the SCPI configuration form, the AgilentTranslator Framework starts and loads theAgilent.LCA.SCPI.Module. The LCA Server cannot handlemore than one session. Therefor you can run either the LCAMeasurement Setup application or the LCA SCPIinterface, but not both in parallel. This is the same for theLCA Remote Client. It also connects to the LCA Server andtherefore the SCPI interface cannot run at the same time.OverviewThe LCA SCPI commands do not fulfill the IEEE standard.They just offer a simple way to control the LCA application ona LAN dependent socket port or on a USB port.Except for the *IDN? and :SYST:ERR? Commands, there isalways a direct relation between a SCPI command and amethod or property of the LCA.Net Remote Interface.LCA SCPI CommandsCommand Tree*CLS[:LCA]:PNUMber? -> [:LCA]:SNUMber? -> [:LCA]:SOFTware:VERSion? -> :LOAD:OO:CALibration:NAME noquery “”:LOAD:OE:CALibration:NAME noquery “”:MEASurement:ABORt:MEASurement:CALData:SAVE noquery “”:MEASurement:CURRent:TYPE? -> :MEASurement:INITialize:EE:MEASurement:INITialize:EO:MEASurement:INITialize:OE:MEASurement:INITialize:OO:MEASurement:STARt Remote Operation46Keysight N437x Series Lightwave Component Analyzer, Programmer’s Guide