Keysight Technologies N9038A Installation Note

Also see for N9038A: Getting started guide Installation note

Contents

Keysight Technologies N9038A Installation Note Manual pdf 14 page image

14 Installation Note N9038-90040Option HL6 – External Mixing Upgrade - Hardware PlusFront Frame Assembly Modification18.Referring to Figure 6, remove the RPG knob (1) from the face of the front frame assembly byfirmly grasping it and pulling it straight off of its shaft. This knob will be reused.Figure 6 A1 Front Frame Assembly19.Remove the main Keyboard overlay (2) by carefully prying it loose from the front frameassembly. It will be easiest to start loosening it around either the RF Input connector or theRPG. The overlay will not be reused.20.Locate the new A1A1MP2 Main Keypad Overlay (N9038-80001) and carefully install byremoving the paper backing material and adhering it to the front frame assembly. Carefullyalign it so that it does not contact any of the front panel keys or connections.21.Reinstall the original RPG knob (1) by aligning the flat spot on the shaft with the flat spot onthe back of the knob and press it on firmly until the shaft bottoms out in the knob.22.Locate the following new parts:23.Discard the nut and lock washer that comes with the new J3 connector.J3 Front Panel Connector – External Mixing 1250-1666W46 Cable, Semi-Rigid, Front Panel J3 to W46 N9020-20166n/a Nut, Hex 1/4-36-thread, .125-in-thick 2950-0223n/a Washer, Lock Internal Tooth, 1/4-in .256-in-ID 2190-0067