Keysight Technologies N9040B UXA Installation Note

Also see for UXA N9040B: Installation notes Installation note Getting Started and Troubleshooting Guide Manual

Contents

tools required

6 Installation Note N9040-90014Option RTS, StreamingAssemble the WBDIF Extension board, Bracket, and Flex Circuit1. Locate the WBDIF Extension board and the bracket in the kit. Attach the WBDIF Extensionboard to the bracket with four screws from the kit. See Figure 1. Torque to 9 inch-pounds.Figure 1 WBDIF Extension Board Bracket2. Locate the gasket in the kit. Notice the gasket has a small square hole and needs to be alignedwith the square hole on the WBDIF Extension Board casting. There is an LED in the casting, andthe small square hole allows the LED to be visible from the rear panel.The gasket is fragile. Carefully peel off the backing from the gasket and apply the sticky side ofthe gasket over the two WBDIF Extension board connectors.3. If the instrument has Option B2X, locate the N9040-60047 Flex cable in the kit. Attach the endof the flex cable that has the alignment pins to the WBDIF Extension board J1.4. If the instrument has Option B5X, locate both flex cables in the kit. Attach flex cableN9040-60047 to the WBDIF Extension board J1. Attach flex cable N9040-60048 to the WBDIFExtension board J2.