Keysight Technologies UXA N9040B Getting Started And Troubleshooting Manual

Also see for CXA N9000B: Manual

Contents

Keysight Technologies UXA N9040B Getting Started And Troubleshooting Manual Manual pdf 57 page image

X-Series Signal Analyzers Getting Started and Troubleshooting Guide 57Instrument Operating SystemDisk Drive Partitioning and UseDisk Drive Partitioning and UseThe drive is partitioned into 3 sections: C:, D: and E:— The C: partition contains the Windows 10 operating system and softwareinstalled by Keysight. This is an Open System which means you can installadditional software, and these should be installed on the C: drive. However,only a limited set of software applications are tested for use with theKeysight measurement software. The installation and/or use of othersoftware is not warranted and could interfere with the operation of themeasurement software. If instrument repair is ever needed, the Keysightversion of the C: drive is the only part of the instrument software that isrestored by the Instrument Recovery process. You must reload any othersoftware that you have added in the instrument.— The D: partition is reserved for data storage. The User Accounts that areconfigured by Keysight have their My Documents folder mapped to the D:drive. This is for the convenience of backing-up the measurement data. Youshould always back-up the data on the D: drive to an external device. Thisallows you to restore the data if you ever need to replace the disk drive.— The E: partition is reserved for Keysight’s use. The primary use of the E:drive is for housing the Calibration and Alignment data. Do not change oroverwrite the files on this drive. This could cause your instrument to notmeet specifications, or even to stop functioning correctly. Do not use thisdrive for data storage. It is also recommended that you back up thecontents of this drive by using the factory calibration data backup utility.Backing-up the factory calibration dataTo back up the factory calibration data to an external location, you will need aUSB storage device.Instruments running Window 10 should have an internal CAL_BACKUP F: drive,which is the default backup location.Table 3-4Step Notes1. Press System, Alignments,Backup/Restore Align Data...You may be prompted for the administrator password.Enter Keysight4u!An information window appears that informs you thatthe instrument must shut down to complete thebackup:"Press OK to force shut down andproceed. Press Cancel to exit."